-
Typical use on straight and level guardrails, to connect the upright to the top rail, or end or mid rail to the upright. Tubes cannot be joined inside a reference 101 fitting. To join tubes inside the fitting use a 104. Item BTUBE101A is often used in conjunction with fitting reference 125. -
Typical use on straight and level guardrails, to connect the upright to the top rail. Tubes can be joined inside of 104 fittings. Item BTUBE104A is often used in conjunction with fitting reference 119. -
Typical use on straight and level guardrails, to connect the mid rails to the upright at a 90° corner. Item BTUBE116A is often used in conjunction with the 128 fitting.
-
Typical use on straight and level guardrails, to connect the mid rails to the upright. The uprights in guardrails must remain continuous with the cross rails being cut. Normally used in conjunction with the 104 fitting.
-
Typical use on straight and level guardrails, to connect the top rails to the upright. Normally used in conjunction with the 101 fitting. This fitting can also be used to create a 90° tube bend.
-
Multitrade Malta BTUBE176A - Side Outlet Tee 176-A (26.9mm) Tube Clamp or Key Clamps for 26.9mm hand rail tube. This malleable iron casting is also available in 33.7mm tube clamps, 42.4mm tube clamps, 48.3mm tube clamps, and 60.3mm tube clamps.Complies with B.S. EN1461. And are also known by the term pipe clamps. Three way tee used to join 3 tubes at 90° to each other with the vertical passing through the fitting. Typical use would be on structures such as market stall or play frames. All clamps come with stainless steel grub screws fitted. If full tightened using a ratchet key to a torque of 4.1kg/m (29ft/lb), the grub screw is capable of withstanding an applied slip load of 900kg
